LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Malibu SS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Connecting Accelerator Pedal Position Sensor Electrical Connector
    GM1544734Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the APP sensor (2).
  2. Install the APP bolts (1).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Connect the APP sensor electrical connector.
  4. Confirm that the APP sensor connector locking clip is fully secured.
scientia non olet · About LEMON Manuals