LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Malibu LS, 2.2 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.2L (L61) - Introduction (2 Of 2) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Throttle Body Attaching Bolts
    GM1238948Courtesy of GENERAL MOTORS CORP.
  1. Inspect the throttle body gasket and replace if necessary.
  2. Install the throttle body to the intake manifold.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the throttle body attaching bolts.

    Tighten:  Tighten the throttle body attaching bolts to 10 N.m (89 lb in).

  4. Connect the throttle body harness connector.
  5. Install the air cleaner resonator. Refer to AIR CLEANER OUTLET RESONATOR REPLACEMENT .
scientia non olet · About LEMON Manuals