Power Windows Inoperative - Lockout Function

POWER WINDOWS INOPERATIVE - LOCKOUT FUNCTION

Step	Action	Yes	No
Schematic Reference: POWER WINDOW SCHEMATICS Connector End View Reference: POWER DOOR SYSTEMS CONNECTOR END VIEWS
1	Did you perform the Vehicle Diagnostic System Check?	Go to Step 2	Go to DIAGNOSTIC SYSTEM CHECK - VEHICLE
2	Verify that the power windows lockout function is inoperative. Does the power windows lockout function operate normally?	Go to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS	Go to Step 3
3	Disconnect the driver window switch. Turn ON the ignition, with the engine OFF. Probe the power window master switch lockout signal circuit of the driver window switch with a test lamp that is connected to a good ground. Does the test lamp illuminate?	Go to Step 4	Go to Step 5
4	Repair the short to voltage in the power window master switch lockout signal circuit. Refer to WIRING REPAIRS . Did you find and correct the condition?	Go to Step 7	Go to Step 5
5	Inspect for a poor connections at the harness connector of the driver window switch. Refer to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS and CONNECTOR REPAIRS . Did you find and correct the condition?	Go to Step 7	Go to Step 6
6	Replace the driver window switch. Refer to POWER WINDOW SWITCH REPLACEMENT - LEFT FRONT . Did you complete the replacement?	Go to Step 7	-
7	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2