LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Ignition Switch Replacement >> Removal Procedure

Removal Procedure

CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
    4. Fig 1: Disconnecting/Reconnecting Theft Deterrent Control Module Connector
    GM420192Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the theft deterrent control module connector.
  5. Disconnect the fused jumper assembly connector.
    6. Fig 2: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  6. Slide the theft deterrent control module (2) from the ignition lock cylinder case (1).
    7. Fig 3: Removing/Installing Key Alarm Connector To/From Ignition Lock Cylinder Case
    GM324871Courtesy of GENERAL MOTORS CORP.
  7. Remove the key alarm connector (1) from the ignition lock cylinder case (4).
  8. Remove the 2 tapping screws (3) from the ignition switch assembly (2).
scientia non olet · About LEMON Manuals