LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disconnect The Manifold Absolute Pressure (MAP) Sensor Electrical Connector
    GM1608869Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (1).
  3. Remove the spark plug wire clip from the intake manifold bracket, if necessary.
    4. Fig 2: Removing The Upper Intake Manifold Bolts
    GM1614650Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper intake manifold bolts.
  5. Remove the MAP sensor and bracket.
  6. Remove the MAP sensor seal from the upper intake manifold.
scientia non olet · About LEMON Manuals