LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC C0297 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the control modules for the appropriate engine RPO listed below.
    • L26 - PCM C1 and TAC
    • LD8 - ECM C1 and TCM
  2. Connect a test lamp between the appropriate signal circuit terminal listed below and ground.
    • L26 - TAC terminal 6
    • LD8 - TCM terminal 42
  3. Engine ON, press and release the brake pedal. The test lamp should turn ON and OFF when pressing and releasing the brake pedal.
    • If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit test normal, replace the BCM.
    • If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the BCM.
  4. Ignition OFF, connect the at the appropriate TAC or TCM control module.
  5. Connect a test lamp between the appropriate signal circuit terminal listed below and ground.
    • L26 - PCM terminal 32 C1
    • LD8 - ECM terminal 77 C1
  6. Engine ON, press and release the brake pedal. The test lamp should turn ON and OFF when pressing and releasing the brake pedal.
    • If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the appropriate TAC or TCM.
  7. If all circuit tests normal, replace the appropriate PCM or ECM control module.
scientia non olet · About LEMON Manuals