LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 5.3L - Introduction (2 Of 2) >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing The MAF/IAT Sensor
    GM1556017Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor seal, if necessary.
  2. Install the MAF/IAT sensor to the air cleaner housing.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the MAF/IAT sensor bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 2: Identifying MAF/IAT Sensor
    GM1208107Courtesy of GENERAL MOTORS CORP.
  4. Connect the MAF/IAT sensor electrical connector (2).
  5. Install the air intake duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
scientia non olet · About LEMON Manuals