Installation Procedure

IMPORTANT: Do not tip the battery more than 40 degrees during installation.

Fig 1: View Of Battery Retainer & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the battery.
NOTE: Refer to Fastener Notice .
Install the battery retainer (2) and bolts (1).
Tighten: Tighten the bolts to 18 N.m (13 lb ft).

Fig 2: Identifying Negative Battery Cable Terminal & Battery

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable terminal to the battery.
Tighten the positive battery cable terminal nut.
Tighten: Tighten the nut to 15 N.m (11 lb ft).
Position the positive battery cable terminal cover (2).
Install the right front diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (RPOs LZE/LZ4/LZ9) or Battery Negative Cable Disconnect/Connect Procedure (RPO LS4) .