Front Door Window Regulator Motor Replacement

Fig 1: Replacing Front Door Window Regulator Motor

Courtesy of GENERAL MOTORS CORP.

Window Regulator Motor Replacement - Front Door

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Position window approximately half way down in the door. Remove the interior trim panel. Refer to Trim Panel Replacement - Side Front Door (Impala) . Remove the water deflector. Refer to Water Deflector Replacement - Front Door (Impala) or Water Deflector Replacement - Front Door (Monte Carlo) . Tape the window to door frame to prevent it from moving. Remove the front door window regulator. Refer to Window Replacement - Front Door (Impala) or Window Replacement - Front Door (Monte Carlo) .
1	Screw, Front Side Door Window Regulator Motor (Qty: 3) Tighten: 4.6 N.m (41 lb in)
2	Motor, Front Side Door Window Regulator Tip: Disconnect the electrical connector from the window regulator motor.

Callout

Component Name

NOTE: Refer to Fastener Notice .

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

Position window approximately half way down in the door.
Remove the interior trim panel. Refer to Trim Panel Replacement - Side Front Door (Impala) .
Remove the water deflector. Refer to Water Deflector Replacement - Front Door (Impala) or Water Deflector Replacement - Front Door (Monte Carlo) .
Tape the window to door frame to prevent it from moving.
Remove the front door window regulator. Refer to Window Replacement - Front Door (Impala) or Window Replacement - Front Door (Monte Carlo) .

Screw, Front Side Door Window Regulator Motor (Qty: 3)

Tighten: 4.6 N.m (41 lb in)

Motor, Front Side Door Window Regulator
Tip: Disconnect the electrical connector from the window regulator motor.