Replacing Keys

Replacing or Relearning Vehicle Keys

IMPORTANT: When performing the 30-Minute Relearn Procedure, all previously learned keys will be erased from the TDM memory. Additional keys may be learned after the completion of the 30-Minute Relearn Procedure by using the Adding Keys procedure.

When the correct number of learned master keys are not available to perform adding keys procedure the 10-minute re-learn procedure must be performed. Refer to Programming Theft Deterrent System Components

30-minute Vehicle Key Relearn

IMPORTANT: This procedure will only relearn the vehicle keys. This procedure will not learn the theft deterrent pre-release password or the challenge/response data. Do not use this procedure as a substitute for a 10-minute relearn when replacing or reprogramming a TDM or ECM. Doing so will result in a failure to learn the pre-release password and/or the challenge/response data.

This 30-minute learn procedure should be used when all vehicle keys are desired to be replaced or reprogrammed. This procedure will erase all previously learned vehicle keys from the TDM. Once the 30-minute learn procedure has been completed, all vehicle keys must be relearned to ensure their continued functionality.

With a master vehicle key, turn ON the ignition, with the engine OFF.
Observe the security indicator, after approximately 10 minutes the telltale will turn off.
Turn OFF the ignition, and wait 5 seconds.
Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes.
IMPORTANT: The TDM learns the key transponder information upon the ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
With a master vehicle key, start the vehicle. The vehicle has now learned the key transponder information.
If additional keys are required to be learned, refer to Adding Keys
With a scan tool, clear any DTCs.