LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Computer/Integrating Systems >> Diagnostic Information and Procedures >> DTC B1441 >> Component Testing

Component Testing

  1. With the key out of ignition and with the key in ACC, measure for infinite resistance between the battery positive voltage and the off/run/crank voltage terminals of the ignition switch. Repeat the same measurement between the ignition key resistor signal and the off/run/crank voltage terminals of the ignition switch.
    • If less than infinite ohms, replace the ignition switch.
  2. With the key in ignition, in OFF position, measure for less than 1 ohm between the battery positive voltage and the off/run/crank voltage terminals at the ignition switch.
    • If over 1 ohm, replace the ignition switch.
  3. With the key in the RUN position, measure for less than 1 ohm between the ignition key resistor signal and the off/run/crank voltage terminals at the ignition switch.
    • If over 1 ohm, replace the ignition switch.
  4. With the key in the START position, measure for 1170-1430 ohms between the ignition key resistor signal and the ignition off/run/crank terminals at the ignition switch.
    • If out of range, replace the ignition switch.
scientia non olet · About LEMON Manuals