Circuit/System Testing
IMPORTANT:
The CKP System Variation Learn Procedure may have to be repeated up to 5 times before the procedure is learned.
- Perform the CKP System Variation Learn Procedure . The scan tool should display Learned this Ignition.
- If the CKP System Variation Learn Procedure cannot be performed successfully, inspect for the following conditions:
- Any worn crankshaft main bearings.
- A damaged or misaligned reluctor wheel.
- Excessive crankshaft runout.
- A damaged crankshaft-Refer to Crankshaft and Bearings Cleaning and Inspection .
- Interference in the signal circuit of the CKP sensor.
- The ignition switch is in the ON position until the system voltage is insufficient.
- An ECM power disconnect with the ignition ON that may have erased the CKP system variation values and set DTC P0315.
- Any debris between the CKP sensor and the reluctor wheel
- If the control module is unable to complete the learn procedure, replace the control module.