LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Impala Police, 3.5 K >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Ignition Coil(s) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing 4 Screws Securing Ignition Coil And Module Assembly To Bracket
    GM1238999Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil.
    NOTE: Refer to Fastener Notice .
  2. Install the ignition coil bolt.

    Tighten:  Tighten the bolts to 4.5 N.m (40 lb in).

    3. Fig 2: Connecting The Right Side Spark Plug Wires To The Ignition Coil
    GM1608803Courtesy of GENERAL MOTORS CORP.
  3. Connect the right side spark plug wires to the ignition coil.
    4. Fig 3: Connecting The Left Side Spark Plug Wires To The Ignition Coil
    GM1608802Courtesy of GENERAL MOTORS CORP.
  4. Connect the left side spark plug wires to the ignition coil.
    5. Fig 4: Connecting The Ignition Coil Electrical Connector
    GM1608869Courtesy of GENERAL MOTORS CORP.
  5. Connect the ignition coil electrical connector (6).
  6. Connect the MAP sensor electrical connector (1).
  7. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals