Inflatable Restraint Roof Rail Module Replacement - Front

Fig 1: Inflatable Restraint Roof Rail Module Replacement - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS. CAUTION: Refer to SIR Caution . CAUTION: Refer to SIR Inflator Module Handling and Storage Caution . NOTE: Refer to Fastener Notice Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 for the left side or SIR Disabling and Enabling Zone 6 . Remove the windshield pillar garnish molding. Refer to Windshield Garnish Molding Replacement . Remove the upper center pillar trim panel. Refer to Trim Panel Replacement - Upper Center Pillar . Remove the rear quarter upper trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper . Remove the coat hooks. Refer to Coat Hook Replacement . Lower the side of the headliner. Refer to Headliner Replacement .
1	Retainer, Push Pin (Qty: 4)
2	Bolt, Inflatable Restraint Roof Side Rail (Qty: 8) Tighten: 9 N.m (80 lb in)
3	Module Assembly, Inflatable Restraint Roof Side Rail Tip: Remove the connector position assurance (CPA) retainer. Disconnect the electrical connector. Ensure the roof rail inflator has been fully deployed before disposal. Refer to Inflator Module Handling and Scrapping .