Installation Procedure

IMPORTANT: After installing the control valve body assembly, the shift adapts must be reset. Reset the shift adapts using the scan tool. Go to Trans Adaptives Reset under Special Functions on the scan tool.

Fig 1: Identifying Valve Body Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the control valve body mounting and the bolts.
Tighten: Tighten the valve mounting bolts to 8 N.m (71 lb in) .
Install the input speed sensor mounting bolt.
Tighten: Tighten the input speed sensor mounting bolts to 8 N.m (71 lb in) .

Fig 2: View Of A/T Output Speed Sensor And Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Install the output speed sensor mounting bolt.
Tighten: Tighten the output speed sensor mounting bolts to 6 N.m (53 lb in) .
Install the oil pan and the oil pan gasket. Refer to Oil Pan and Gasket Removal .

Fig 3: Locating Drain Plug

Courtesy of GENERAL MOTORS CORP.

Use the DT 46475 (1) to install the transaxle fluid drain plug. See Special Tools .
Install the engine under cover.

Fig 4: View Of Park/Neutral Position Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Lower the vehicle.
Connect the transaxle wiring harness and the park/neutral position (PNP) switch electrical connector.
Refill the transaxle fluid. Refer to Transmission Fluid Level Inspection .

Install the battery.