LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Electrical >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Head Up Display Replacement >> Installation Procedure

Installation Procedure

Fig 1: Installing HUD Assembly
GM378935Courtesy of GENERAL MOTORS CORP.
  1. Transfer the retaining screw and nut to the replacement HUD.
  2. Install the HUD to the vehicle:
    1. Install the HUD onto the dash panel mounting studs.
    2. Slide the HUD retaining screw into the slot on the steering column bracket.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the HUD retaining nuts.

    Tighten:  Tighten the nuts to 5 N.m (44 lb in).

  4. Tighten the screw that retains the HUD to the steering column bracket.

    Tighten:  Tighten the screw to 3 N.m (27 lb in).

  5. Install the I/P assembly. Refer to Instrument Panel (I/P) Assembly Replacement .
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (7.0L) or Battery Negative Cable Disconnect/Connect Procedure (6.0L) in Engine Electrical.
scientia non olet · About LEMON Manuals