LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Chevy Express G3500, Van Passenger Extended >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement (w/JL4) >> Installation Procedure

Installation Procedure

    Fig 1: Brake Pressure Modulator Valve & Electronic Brake Control Module
    GM1381552Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
  1. Install the EBCM (2) on to the BPMV (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws to the EBCM (2).

    Tighten:  Tighten the screws to 5 N.m (44 lb in) in an X-pattern.

    3. Fig 2: Identifying Chassis Electrical Connectors To EBCM
    GM924296Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connectors to the EBCM.
    4. Fig 3: Splash Shield (Cutaway Vehicles)
    GM1209085Courtesy of GENERAL MOTORS CORP.
  4. For cutaway vehicles, install the splash shield.

    Tighten:  Tighten the splash shield bolts to 25 N.m (18 lb ft).

  5. Lower the vehicle.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  7. Revise the tire calibration using the Tire Size Calibration function.
  8. Verify correct system operation. Refer to Diagnostic Starting Point - Anti-Lock Brake System .
scientia non olet · About LEMON Manuals