LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Venture LS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Reverse Servo Replacement >> Removal Procedure

Removal Procedure

  1. Remove the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.4L.
    2. Fig 1: Removing/Installing Reverse Servo Cover Snap Ring
    GM48166Courtesy of GENERAL MOTORS CORP.
  2. Use a large flat-bladed tool in order to depress the reverse servo cover (40).
  3. Use a small flat-bladed tool in order to remove the retaining ring (39).
    4. Fig 2: O-Ring Seal
    GM48171Courtesy of GENERAL MOTORS CORP.
  4. Use a small flat-bladed tool in order to pull the O-ring seal (41) out through the slot in the case.
  5. Use side cutting pliers in order to cut the servo cover O-ring seal (41).
  6. Use a large flat-bladed tool in order to depress the reverse servo cover (40), grasp one end of the cut seal (41) and pull the seal (41) out of the servo cover (40).
    7. Fig 3: Identifying Reverse Servo Assembly Components
    GM48173Courtesy of GENERAL MOTORS CORP.
  7. Remove the reverse servo cover (40).
  8. Remove the servo assembly (42-48).
  9. Remove the servo spring (49).
scientia non olet · About LEMON Manuals