LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Venture LS >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension Control System - Suspension Leveling >> Repair Instructions >> Inflator Solenoid Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Inflator Solenoid
    GM381393Courtesy of GENERAL MOTORS CORP.
  1. Install the inflator solenoid washer over the fill valve.
  2. Install the inflator solenoid.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the inflator solenoid nut.

    Tighten:  Tighten the inflator solenoid nut to 3 N.m (27 lb in).

  4. Install the inflator solenoid fill valve nut.

    Tighten:  Tighten the inflator solenoid fill valve nut to 3 N.m (27 lb in).

  5. Install the inflator solenoid fill valve cap.
    6. Fig 2: Locating Inflator Solenoid Electrical Connector
    GM880782Courtesy of GENERAL MOTORS CORP.
  6. Install the air lines to the inflator solenoid.
  7. Connect the inflator solenoid electrical connector.
  8. Install the inflator control panel.
  9. Install the inflator air valve opening cover by pushing the lever outboard.
  10. Install the ELC/TRAILER fuse.
scientia non olet · About LEMON Manuals