LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Venture LS >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Ignition Switch Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Steering Column Wiring Harness Assembly
    GM360577Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Remove the wire harness assembly (4) from the wire harness strap (5).
  4. Remove the wire harness straps (3) from the wire harness assembly (4).
  5. Remove the wire harness strap (2) from the upper tilt head assembly (1).
    6. Fig 2: Turn Signal & Multifunction Switch Assembly Connectors
    GM306234Courtesy of GENERAL MOTORS CORP.
  6. Slide the turn signal switch assembly connectors (2) out from the bulk head connector (1).
    7. Fig 3: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  7. Pull the PASSKEY® III (2) off of the ignition lock cylinder case (1).
    8. Fig 4: Expanded View Of Key Alarm Connector To Ignition Lock Cylinder Case
    GM324882Courtesy of GENERAL MOTORS CORP.
  8. Remove the key alarm connector (1) from the ignition lock cylinder case (2).
  9. Remove the 2 tapping screws from the ignition switch assembly (3).
scientia non olet · About LEMON Manuals