LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Venture LS >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7  or SIR Disabling and Enabling Zone 9 .
  2. Remove the passenger front seat. Refer to Seat Replacement - Bucket in Seats.
  3. Remove the passenger front carpet retainer, then roll back the carpet.
    4. Fig 1: Locating Inflatable Restraint Sensing And Diagnostic Module Components
    GM260605Courtesy of GENERAL MOTORS CORP.
  4. Push the locking tab and release the connector position assurance (CPA) from the inflatable restraint sensing and diagnostic module (SDM) wiring harness connector (2).
    5. Fig 2: Locating SDM Wiring Harness Connector
    GM260607Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the SDM wiring harness connector (3) from the SDM (1).
    6. Fig 3: Locating SDM Mounting Fasteners
    GM260608Courtesy of GENERAL MOTORS CORP.
  6. Remove the SDM mounting fasteners (1).
  7. Remove the SDM (2) from the vehicle.
scientia non olet · About LEMON Manuals