Conditions for Clearing the DTC
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.
DTC P1114
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Connector End Views or Powertrain Control Module (PCM) Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Observe the DTC information with a scan tool. Is DTC P0117 set? |
Go to DTC P0117 | Go to Step 3 |
| 3 | Observe the engine coolant temperature (ECT) parameter with a scan tool while moving the ECT sensor connector and the powertrain control module (PCM) connector. Does the scan tool indicate an abrupt change in value? |
Go to Step 5 | Go to Step 4 |
| 4 | Observe the ECT parameter with a scan tool while moving the wiring harness at the ECT sensor and the PCM. Does the scan tool indicate an abrupt change in value? |
Go to Step 6 | Go to Step 7 |
| 5 | Repair the connector/terminal as necessary. Refer to Circuit Testing
and Connector Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 7 | - |
| 6 | Repair the harness/wiring as necessary. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 7 | - |
| 7 |
|
Go to Step 2 | Go to Step 8 |
| 8 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |