LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Venture LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.4L DTC P0140 To P0443 >> DTC Tests >> DTC P0420 >> Diagnostic Aids

Diagnostic Aids

DTC P0420

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Allow the engine to reach operating temperature.
  2. Ensure Closed Loop is achieved.
  3. Increase the engine speed to 1,500 RPM for 2 minutes.
  4. Return the engine to a stabilized idle.
  5. Monitor the HO2S 1 and the HO2S 2 voltage parameters on the scan tool.
Is the HO2S 2 voltage parameter as active as the HO2S 1 voltage parameter?
Go to Step 4  Go to Step 3 
3
IMPORTANT: If more than 6 tests have been attempted and the DTC has not passed or failed this ignition cycle, the test may be aborting. Refer to Diagnostic Aids. The test may need to be completed up to 6 times in order to pass or fail.
  1. Observe the Freeze Frame/Failure Records for this DTC.
  2. Clear the DTCs with a scan tool.
  3. Turn OFF all accessories.
  4. Operate the vehicle within the Conditions for Running this DTC.
Does the scan tool indicate DTC P0420 ran and passed this ignition?
Go to Diagnostic Aids Go to Step 4 
4
IMPORTANT: Verify that the three-way catalytic converter (TWC) is a high quality part that meets the original equipment manufacturer (OEM) specifications.
Visually and physically inspect the catalytic converter for the following conditions:
  • Dents
  • A severe discoloration caused by excessive temperatures
  • Road damage
  • An internal rattle caused by damaged catalyst substrate
  • Restrictions - Refer to Restricted Exhaust .
Did you find a condition?
Go to Step 8  Go to Step 5 
5 Visually inspect the exhaust system for the following conditions:
  • Leaks - Refer to Exhaust Leakage .
  • Physical damage
  • Loose or missing hardware
  • The heated oxygen sensor (HO2S) 2 for proper torque

Did you find and correct the condition?
Go to Step 9  Go to Step 6 
6 Visually inspect the HO2S 2 for the following conditions:
  • The pigtail and wiring harness contacting the exhaust or a ground
  • Physical damage

Did you find a condition?
Go to Step 7  Go to Step 8 
7 Replace the HO2S 2 sensor. Refer to Heated Oxygen Sensor Replacement - Position 2 .
Did you complete the replacement?
Go to Step 9  -
8
NOTE: Refer to Three-Way Catalytic Converter Damage Notice in Cautions and Notices.
Replace the catalytic converter. Refer to Catalytic Converter Replacement .Did you complete the replacement?
Go to Step 9  -
9
  1. Clear the DTCs with a scan tool
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?
Go to Step 2  Go to Step 10 
10 Observe the Capture Info with a scan tool.
Are there any DTCs that you have not diagnosed?
Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK