Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing & Installing Oil Pan

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the oil pan gasket, the oil pan, and hand start the oil pan bolts.
Tighten: Tighten the oil pan bolts to 12 N.m (9 lb ft).
Lower the vehicle.
Refill the transaxle using DEXRON® III P/N 21019223 transaxle fluid or equivalent to the specified refill capacity. Refer to Transmission Fluid Checking Procedure .
Specification:
- The bottom pan removal capacity is approximately 6.5 L (6.9 qt).
- The complete overhaul capacity is approximately 9 L (9.5 qt).
- The dry capacity is approximately 12.2 L (12.9 qt).
Start the engine. Warm up the transaxle, and check for leaks.
Inspect for proper fluid level. Refer to Transmission Fluid Checking Procedure .