Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Mode Actuator Screws

Courtesy of GENERAL MOTORS CORP.

Install the mode actuator.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the mode actuator screws.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
Install the mode actuator wire harness connector.
Close I/P compartment door. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
Install the fuse labeled HVAC CTRL (BATT).