LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Passenger Extended >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Lower Control Arm Bushings Replacement >> Removal Procedure

Removal Procedure

  1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
  2. Secure the lower control arm in a vice.
    3. Fig 1: Scribing Orientation Of Control Arm Bushing On Lower Control Arm
    GM381812Courtesy of GENERAL MOTORS CORP.
  3. Mark the lower control arm along the flat edge of the bushing flange.
    4. Fig 2: View Of J 21474-01
    GM381816Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply J 23444-A  , or equivalent high pressure lubricant, to the threads of the J 21474-27. See Special Tools .
  4. Assemble the following bushing removal tools as shown:
    • J 21474-27 1/2 Inch Puller Bolt Thrust Bearing
    • J 21474 Control Arm Bushing Installer
    • J 34126  Sprocket Bearing Remover. See Special Tools .
    • J 35379  Front Knuckle Support. See Special Tools .
    • J 21474-2 Bushing Installer Remover
    • J 21474-4 1/2 Inch Nut
  5. Tighten the J 21474-4 until the bushing is removed from the control arm.
  6. Disassemble the bushing removal tools.
scientia non olet · About LEMON Manuals