LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Passenger Extended >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Lower Ball Joint Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Lower Ball Joint
    GM385752Courtesy of GENERAL MOTORS CORP.
  1. Install the ball stud to the lower control arm.
    2. Fig 2: Identifying Ball Joint Retaining Nuts
    GM385756Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW ball stud bolts facing down, away from the ball stud.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: This is a prevailing torque type fastener. This fastener may be reused ONLY if:
    • The fastener and its counterpart are clean and free from rust
    • The fastener develops 2 N.m (18 lb in) of torque/drag against its counterpart prior to the fastener seating.

    If the fastener does not meet these criteria, REPLACE the fastener.
  3. Install the NEW ball stud nuts.

    Tighten:  Tighten the NEW ball stud nuts to 68 N.m (50 lb ft).

  4. Install the lower control arm. Refer to Lower Control Arm Replacement .
scientia non olet · About LEMON Manuals