LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Passenger Extended >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Upper Pinch Bolt Of Intermediate Steering Shaft
    GM454259Courtesy of GENERAL MOTORS CORP.
  1. Connect the intermediate steering shaft to the steering column.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the intermediate steering shaft upper pinch bolt at the steering column.

    Tighten:  Tighten the bolt to 48 N.m (35 lb ft).

    3. Fig 2: View Of Intermediate Steering Shaft To Power Steering Gear Stub Shaft
    GM294371Courtesy of GENERAL MOTORS CORP.
  3. Install the intermediate steering shaft seal onto the steering column.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Connect the intermediate steering shaft (1) to the power steering gear stub shaft (2).
  6. Install the intermediate steering shaft lower pinch bolt at the power steering gear stub shaft.

    Tighten:  Tighten the bolt to 48 N.m (35 lb ft).

    7. Fig 3: Providing Access To Intermediate Steering Shaft Lower Pinch Bolt
    GM294376Courtesy of GENERAL MOTORS CORP.
  7. Install the intermediate steering shaft seal onto the power steering gear.
  8. Lower the vehicle.
  9. Install the left sound insulator. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages, and Console.
  10. Remove the J 42640  from the steering column. See Special Tools .
scientia non olet · About LEMON Manuals