LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Passenger Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Rear Suspension System) >> Repair Instructions >> Trailing Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Trailing Arm To Bracket Bolt And Nut
    GM1237910Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Assemble the trailing arm and bracket.

    Tighten:  Tighten the trailing arm to bracket through bolt to 60 N.m (44 lb ft) plus 60 degrees.

  2. Position the trailing arm to the vehicle.
    3. Fig 2: Removing Trailing Arm To Knuckle Bolts
    GM1237904Courtesy of GENERAL MOTORS CORP.
  3. Install the trailing arm to knuckle bolts.

    Tighten:  Tighten the bolts to 180 N.m (133 lb ft).

  4. Connect the parking brake cable to the trailing arm. Refer to Park Brake Cable Replacement - Rear (Rear Disc Brakes) or Park Brake Cable Replacement - Rear (Rear Drum Brakes) in Park Brake.
    5. Fig 3: Removing Trailing Arm Bracket To Body Bolts
    GM1237908Courtesy of GENERAL MOTORS CORP.
  5. Install the trailing arm bracket to body bolts.

    Tighten:  Tighten the bracket to body bolts to 90 N.m (66 lb ft) plus 30 degrees plus an additional 15 degrees.

  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals