LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Passenger Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Rear Suspension System) >> Repair Instructions >> Rear Axle Lower Control Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower control arm spring insulators.
  2. Position the lower control arm to the support assembly.
    3. Fig 1: Removing Lower Control Arm To Support Assembly Bolt And Nut
    GM1361415Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the lower control arm to support assembly bolt and nut.

    Tighten:  Tighten the nut and bolt to 110 N.m (81 lb ft).

  4. Install the rear spring. Refer to Coil Spring Replacement .
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
  7. Check the rear alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.
scientia non olet · About LEMON Manuals