Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Trailing Arm To Knuckle Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the trailing arm to knuckle bolts.
Tighten: Tighten the bolts to 180 N.m (133 lb ft).

Fig 2: Installing Upper Control Arm To Knuckle Bolt And Nut

Courtesy of GENERAL MOTORS CORP.

Install the upper control arm to knuckle bolt and nut.
Tighten: Tighten the bolt and nut to 110 N.m (81 lb ft) plus 70 degrees.

Fig 3: Removing Upper Control Arm To Knuckle Bolt And Nut

Courtesy of GENERAL MOTORS CORP.

Install the toe link. Refer to Toe Link Replacement .
Install the coil spring. Refer to Coil Spring Replacement .

Fig 4: Removing Lower Shock To Knuckle Bolt

Courtesy of GENERAL MOTORS CORP.

Install the lower shock absorber to knuckle bolt.
Tighten: Tighten the bolt to 180 N.m (133 lb ft).

Fig 5: Removing Stabilizer Shaft To Knuckle Bolts

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer link to the knuckle.
Tighten: Tighten the bolt to 50 N.m (37 lb ft).
Install the rear wheel bearing and brake components. Refer to Wheel Bearing/Hub Replacement - Rear .
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.