LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Keyless Entry System) >> Diagnostic Information and Procedures >> DTC B3109 >> Test Description

Test Description

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 1:  This step performs the Diagnostic System Check.
  2. 2:  This step checks DTC status as current or history in Remote Function Actuation Menu on the scan tool.
  3. 3:  This step identifies the key fob #, transmitter, with a low battery signal.
  4. 4:  This step verifies that the battery replacement corrected the fault.
DTC B3109

Step Action Yes No
Schematic Reference: Keyless Entry Schematics 
Connector End Views: Keyless Entry Connector End Views 
1  Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Select Body and Accessories.
  4. Select Keyless Entry.
  5. Select Diagnostic Trouble Codes.
Does the scan tool display DTC B3109 as a current DTC?		 Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3 
  1. With a scan tool, observe the Key Fob Low Voltage parameters for each transmitter in the Door Lock Information data list to identify the programmed transmitter that set the code.
  2. Replace the batteries on the indicated transmitters. Refer to Transmitter Battery Replacement .
Did you complete the battery replacement?		 Go to Step 4  -
4 
  1. Use the scan tool in order to clear DTCs.
  2. Operate for 3 consecutive times the transmitters that had the battery replaced.
Does the DTC reset?		 Go to Step 5  System OK
5 Inspect for poor connections at the battery connection of the transmitters that set the DTC.
Did you find and correct the condition?		 System OK Go to Step 6 
6
  1. Replace the transmitter.
  2. Ensure that the replacement transmitter is the correct model for the vehicle.
  3. All transmitters must be programmed at the same time. Refer to Transmitter Programming .
Did you complete the replacement?		 Go to Step 7  -
7
  1. Use scan tool in order to clear the DTCs.
  2. Operate the replacement transmitters 3 consecutive times.
Does the DTC reset?		 Go to Step 8  System OK
8 Replace the remote control door lock receiver (RCDLR). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 System OK -
scientia non olet · About LEMON Manuals