LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnect/Connect Procedure >> Connect Procedure

Connect Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Connecting Battery Negative Cable To Battery
    GM1275980Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Clean any existing oxidation from the contact face of the battery terminal and battery cable using a wire brush before installing the battery cable to the battery terminal.
  1. Connect the negative battery cable to the battery.

    Tighten:  Tighten the bolt to 17 N.m (13 lb ft).

    2. Fig 2: Disconnecting Battery Negative Cable From Battery
    GM1239095Courtesy of GENERAL MOTORS CORP.
  2. Install the battery cover.
    1. Install the locking tab next to the strut tower first.
    2. Install the locking tab next to the engine second.
    3. Install the locking tab next to the powertrain control module (PCM) last.
  3. Reset the radio stations and the clock.
scientia non olet · About LEMON Manuals