LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Control System - 3.5L (Lx9) - Introduction) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Knock Sensors
    GM909629Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the knock sensor wiring harness electrical connector.
  3. Remove the knock sensor.
scientia non olet · About LEMON Manuals