LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Control System - 3.5L (Lx9) - Introduction) >> Repair Instructions >> Fuel Hose/Pipes Replacement - Engine Compartment >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Vacuum Hoses
    GM1239037Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel feed pipe to the fuel rail Refer to Quick Connect Fitting(s) Service (Metal Collar) .
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine fuel feed pipe fasteners located on the engine.

    Tighten:  Tighten the fuel feed pipe fasteners to 10 N.m (89 lb in).

  3. Connect the engine fuel feed pipe to the chassis fuel flex hose. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  5. Inspect for leaks using the following procedure:
    1. Turn ON the ignition, with the engine OFF for 2 seconds.
    2. Inspect for fuel leaks.
    3. Turn OFF the ignition for 10 seconds.
    4. Turn ON the ignition.
scientia non olet · About LEMON Manuals