LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Control System - 3.5L (Lx9) - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the O-ring with clean engine oil and replace the O-ring if damaged.
    2. Fig 1: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
  2. Install the CMP sensor.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Connect the CMP sensor electrical connector.
scientia non olet · About LEMON Manuals