LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Fuel Sender Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing Sending Unit Lock Ring Using J 45722 (4.8L, 5.3L, and 6.0L)
    GM1302212Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Disconnect the fuel line from the sending unit. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  3. Disconnect the evaporative emission (EVAP) line from the sending unit. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Using J 45722  remove the sending unit lock ring.
    CAUTION: Drain the fuel from the fuel sender assembly into an approved container in order to reduce the risk of fire and personal injury. Never store the fuel in an open container.
  5. Remove the sending unit and seal. Discard the seal.
  6. Clean the sending unit sealing surfaces.
scientia non olet · About LEMON Manuals