LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Rear Suspension System) >> Repair Instructions >> Shock, Shock Component, and/or Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the shock carrier assembly. Refer to Shock Absorber Replacement .
    2. Fig 1: Compressing Shock Absorber Spring
    GM891985Courtesy of GENERAL MOTORS CORP.
  2. Mount the shock carrier assembly into the SA9155S  .
  3. Mount the lower portion of the strut to the SA9155S  .
  4. Compress the spring in order to unload the upper spring supports.
    5. Fig 2: Removing/Installing Upper Shock Shaft Nut
    GM893025Courtesy of GENERAL MOTORS CORP.
  5. Using a wrench and a socket, remove the upper shock shaft nut.
  6. Release the spring compressor tension from the spring in order to remove the shock suspension support carrier.
  7. Remove the remaining components from the shock absorber. Note there location for assembly.
    8. Fig 3: Exploded View Of Rear Shock Absorber Assembly
    GM891987Courtesy of GENERAL MOTORS CORP.
  8. Inspect the inner and outer shock absorber bushings for damage or deterioration and replace if necessary.
  9. Inspect the shock bumper for damage or deterioration and replace if necessary.
  10. Inspect the spring upper insulator and replace if necessary.
  11. If replacing the shock, remove the shock from the SA9155S  .
scientia non olet · About LEMON Manuals