LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> SSR Standard >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Rear Drive Axle >> Repair Instructions >> Rear Axle Replacement >> Installation Procedure

Installation Procedure

  1. Install the rear axle assembly to the vehicle.
  2. Connect the upper control arm to the rear axle. Refer to Rear Axle Upper Control Arm Replacement in Rear Suspension.
  3. Connect the lower control arm to the rear axle. Refer to Rear Axle Lower Control Arm Replacement in Rear Suspension.
  4. Connect the rear axle tie rod to the rear axle. Refer to Rear Axle Tie Rod Replacement in Rear Suspension.
  5. Install the coil springs. Refer to Coil Spring Replacement in Rear Suspension.
  6. Install the stabilizer shaft to the rear axle. Refer to Stabilizer Shaft Replacement in Rear Suspension.
  7. Install the caliper assemblies to the rear axle. Refer to Brake Caliper Replacement - Rear in Disc Brakes.
  8. Connect the right rear cable of the park brake to the rear axle. Refer to Park Brake Cable Replacement - Left Rear and to Park Brake Cable Replacement - Right Rear in Park Brake.
  9. Connect the left rear cable of the park brake to the rear axle. Refer to Park Brake Cable Replacement - Left Rear and to Park Brake Cable Replacement - Right Rear in Park Brake.
  10. Install the propeller shaft to the pinion yoke. Refer to Propeller Shaft Replacement in Propeller Shaft.
  11. Connect the rear axle vent tube.
  12. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  13. Fill the axle with lubricant. Use the proper fluid. Refer to Lubricant Replacement - Rear Drive Axle .
  14. Remove the safety stands.
  15. Lower the vehicle.
scientia non olet · About LEMON Manuals