LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Wheel Speed Sensor Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hub and bearing assembly to the vehicle. Refer to Wheel Bearing/Hub Replacement - Rear in Rear Suspension.
    2. Fig 1: Locating Rear Wheel Speed Sensor Electrical Connector
    GM891504Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the rear wheel speed sensor.
  3. Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Lower the vehicle.
  5. Turn the ignition switch to the ON position, with the engine OFF.
  6. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals