LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust Seal Replacement >> Installation Procedure

Installation Procedure

  1. Install the exhaust manifold pipe seal(s).
  2. Raise the catalytic converter or exhaust manifold pipe using the adjustable jackstands.
    3. Fig 1: View Of Right Exhaust Pipe Nuts
    GM858553Courtesy of GENERAL MOTORS CORP.
  3. Install the right exhaust manifold pipe nuts.
    4. Fig 2: View Of Left Exhaust Manifold Pipe & Nuts
    GM858550Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the left exhaust manifold pipe nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  5. Remove the adjustable jackstands from catalytic converter or exhaust manifold pipe.
    6. Fig 3: View Of O2 Sensor Harness Routing
    GM664951Courtesy of GENERAL MOTORS CORP.
  6. Perform the following:
    1. Connect the oxygen sensor electrical connector (1).
    2. Connect the CPA retainer.
    3. Clip the oxygen sensor electrical connector to the hose clip.
    7. Fig 4: View Of O2 Sensor Harness Routing And Harness Mounting Brackets
    GM664828Courtesy of GENERAL MOTORS CORP.
  7. Perform the following:
    1. Connect the forward oxygen sensor electrical connector.
    2. Connect the CPA retainer.
    3. Install the clip around the engine harness and the oxygen sensor pigtail.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals