LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Optra5 Base, Standard >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Steering Wheel And Column >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Steering Column Cover Panel Screws
    GM1308107Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the upper and the lower steering column cover and panel by removing the screws.
  3. Disconnect the electrical connector for the immobilizer detection coil.
    4. Fig 2: Locating The Detent Spring
    GM1308221Courtesy of GENERAL MOTORS CORP.
  4. With the key in the ignition turned to the position designated ACC, remove the lock cylinder by pressing down the detent spring and pulling the lock cylinder out of the switch cylinder housing.
    5. Fig 3: View Of Ignition Switch Wiring And Retaining Screw
    GM1308230Courtesy of GENERAL MOTORS CORP.
  5. Remove the ignition switch retaining screw.
  6. Disconnect the wiring and remove the ignition switch.
scientia non olet · About LEMON Manuals