LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Optra5 Base, Automatic >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC Systems - Manual >> Repair Instructions >> HVAC Control Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Center Molding
    GM1308246Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the control assembly with the retaining screws to the center molding.

    Tighten:  Tighten the controller retaining screws to 2 N.m (18 lb in)  .

  2. Press the cable end eyelet onto the post on the controller.
  3. Attach the mechanical cable housing to its original control position.
  4. Connect the electrical connectors to the sockets on the back of the controller.
    5. Fig 2: View Of Center Trim Panel
    GM1308250Courtesy of GENERAL MOTORS CORP.
  5. Gently insert the center molding into position on the instrument panel (I/P).
  6. Connect the negative battery cable.
  7. Confirm the proper operation of the controller by moving it through all of the controller's possible functioning positions.
scientia non olet · About LEMON Manuals