LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Impala SS >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Battery Insulator
    GM201375Courtesy of GENERAL MOTORS CORP.
  1. Install the battery insulator to the battery.
    2. Fig 2: Battery, Retainer & Bolt
    GM513047Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do NOT tip the battery more than 40 degrees during removal.
  2. Install the battery (3) to the battery tray.
  3. Install the battery hold down retainer (2).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the battery hold down retainer bolt (1).

    Tighten:  Tighten the bolt to 18 N.m (13 lb ft).

    5. Fig 3: Connecting Battery Cables
    GM289316Courtesy of GENERAL MOTORS CORP.
  5. Connect the positive battery cable.

    Tighten:  Tighten the terminal bolt to 15N.m (11 lb ft).

  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  7. Install the RH fender diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
scientia non olet · About LEMON Manuals