LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Impala SS >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Traction Control Switch Replacement (Impala) >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Traction Control Switch From Cluster Trim Plate (Impala)
    GM814200Courtesy of GENERAL MOTORS CORP.
  1. Install the traction control switch (1) to the IP cluster trim plate (2).
    2. Fig 2: Disconnecting/Reconnecting Traction Control Switch Electrical Connector (Impala)
    GM814203Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector (1) to the traction control switch (2).
  3. Align and carefully press the IP cluster trim plate into the IP trim pad. Make sure all of the retainers are fully engaged.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the LH IP cluster trim plate screws.

    Tighten:  Tighten the IP cluster trim plate screws to 2 N.m (18 lb in).

  5. Install the LH instrument panel (IP) fuse block access opening covers.
  6. Install the ignition switch cylinder bezel.
  7. Return the steering wheel to the original position.
  8. If equipped with a column shift, position the transaxle shift control indicator to Park.
  9. If equipped with column shift, release the parking brake.
scientia non olet · About LEMON Manuals