LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 366 (Shift Interlock System) >> Repair Instructions >> Automatic Transmission Shift Lock Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Shift Lock Actuator Electrical Connector
    GM1538451Courtesy of GENERAL MOTORS CORP.
  1. Install the shift lock actuator (2) to the linear shift assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the shift lock actuator screws (3).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  3. Connect the shift lock actuator electrical connector (1).
    4. Fig 2: Identifying Linear Shift Assembly Bolt/Holes
    GM1538450Courtesy of GENERAL MOTORS CORP.
  4. Rotate the linear shift assembly (2) up to align the linear shift assembly bolt holes.
    5. Fig 3: View Of Shift Lock Actuator Linear Shift Front Bolts
    GM1538449Courtesy of GENERAL MOTORS CORP.
  5. Install the linear shift front bolts (2).

    Tighten:  Tighten the bolts (1, 2) to 10 N.m (89 lb in).

  6. Install the steering column. Refer to Steering Column Replacement in Steering Wheel and Column.
  7. Install the trim covers to the steering column. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
scientia non olet · About LEMON Manuals