Removal Procedure

The (K43) 102 ampere generator is serviced as a complete unit only.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
2. Remove the engine compartment cross vehicle brace. Refer to Brace Replacement - Cross Vehicle in Body Front End.
3. Remove the drive belt from the generator. Refer to Drive Belt Replacement in Engine Mechanical - 3.4L.
4. Reposition the coolant recovery reservoir aside for access. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
Fig 1: Removing/Installing Generator & Bolts (3.1L)
Courtesy of GENERAL MOTORS CORP.
5. Remove the bolts (1,2,3) from the generator.
6. Disconnect the electrical connector from the generator.
7. Position aside the protective boot from the generator output BAT terminal.
8. Remove the generator output BAT terminal nut and remove the positive battery lead from the generator.
9. Remove the generator.