Scan Tool Data List
Powertrain Control Module
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Crank Request Signal | Engine Data 2 | Yes/No | No |
| GEN L-Terminal Signal Command | Engine Data 2 | % | 0% |
| Ignition 1 Signal | Engine Data 1,2 | Volts | 12.6 V |
| Starter Enable Relay Circuit Status | Output Driver Data | Fault/OK/Invalid State | OK |
| Starter Relay Command | Engine Data 2 | On/Off | Off |
Body Control Module (BCM)
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Electronics Battery Feed | Data, Inputs | Volts | 12.6 Volts |
| Load Management Status | Outputs | Active /Inactive | Inactive |
| Inadvertent Power Relay | Outputs | On/Off | On |
Transmission Control Module
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| IMS | Transmission Data | Park, Park/Reverse, Reverse, Reverse/Neutral, Neutral, Neutral/Drive 4, Drive 4, Drive 4/Drive 3, Drive 3, Drive 3/Drive 2, Drive 2, Drive 2/Drive 1, Drive 1, INVALID | Park |