LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Impala LS >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Traction Control Switch Replacement (Monte Carlo) >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Traction Control Switch From Floor Console Trim Plate (Monte Carlo)
    GM578676Courtesy of GENERAL MOTORS CORP.
  1. Install the traction control switch to the floor console trim plate.
  2. Connect the electrical connector to the traction control switch.
    3. Fig 2: Identifying Front Floor Console Trim Plate Screw (Monte Carlo)
    GM578742Courtesy of GENERAL MOTORS CORP.
  3. Carefully install the floor console trim plate. Make sure all of the retainers are fully engaged.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the floor console trim plate screw (1).

    Tighten:  Tighten the floor console trim plate screw to 2 N.m (18 lb in).

  5. Position the transaxle shift control lever to Park.
  6. Install the center console mat.
  7. Release the park brake.
scientia non olet · About LEMON Manuals