LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Cutaway 6.0 U >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Engine Control System - 4.3L - Introduction) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Savana and 2005 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Knock Sensor & Retaining Bolt
    GM679284Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  1. Install the knock sensor (2) and bolt (1).

    Tighten:  Tighten the knock sensor bolt to 25 N.m (18 lb ft).

  2. Connect the KS harness connector (3).
  3. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
scientia non olet · About LEMON Manuals